SF6 gas transfer unit AGTU

Designed as a low cost solution to recovering, consolidating and transferring Sulfur Hexafluoride, the AGTU is an essential tool for servicing small volume SF₆ equipment.

Features:

• Rugged steel enclosure
• Regulated inlet for direct connection to high-pressure bottles without throttling
• High discharge pressure for liquefaction in high ambient temperatures
• Can be used with SF₆ tanks, bottles or carts
• Automatic shut off when maximum allowable pressure is reached
• High pressure, direct-drive oil-less compressor with 1000:1 compression ratio (capable of 1000psi – 69 bar)
• Comes complete with 9.8ft / 3m hoses and power cable
• Filters are easily changed without disconnecting any tubing or using any special tools
• Colour change moisture indicator to monitor moisture in gas
• Purifies, dries and filters to 0.1 microns during recovery and re-pressurization:
  • (D1) - Dryer Filter - Contains activated alumina to aid in the drying and purification of SF₆ Gas
  • (F1) - Particulate Filter - Will filter all particulate matter down to 0.1 micron nominal

Applications:

• Recover SF₆ gas to an optionally available auxiliary storage tank
• Pressure regulated recharging of SF₆ gas to switch gear
• Consolidation of storage cylinders
• Purification of SF₆ (removes particles, moisture, and SF₆ decomposition products)

AGTU - Specifications
Type	Portable SF6 Gas Transfer Unit
Physical specifications	25" (635 mm) Wide x 16" (410 mm) Deep x 20" (510 mm) // 75 lbs. (34 kgs.)
Input power	120Vac/60Hz - 220Vac/50Hz
Filters	(D1) - Dryer Filter - Contains activated alumina to aid in the drying and purification of SF6 Gas (F1) - Particulate Filter - Will filter all particulate matter down to 0.1 micron nominal
Hoses	Two Permeation Rubber Resistant Hoses: 1/4" (6 mm) I.D. X 10 Ft. (0.91 meter) Long, complete with quick disconnect self-sealing end fittings. Hoses will be suitable for system pressure, temperature and flow.
AGTU - Optional Upgrades and Accessories
DN-8 Style Quick Connections	Unit can be supply with DN-8 style quick connections on equipment and hoses
Increase Hose Length	Unit can be supply with 6m. hoses instead of 3m.
AGTU– Spare Parts
Filter D-1	Dryer Filter – recommended to change each 50 hours of compressor work
Filter F-1	Particulate Filter – recommended to change each 50 hours of compressor work